Cables

Cable to extend XBus connections.

This 3 pin cable delivers power, signal and ground connection to both digital and analog sensors. Each cable features a 4 pin connection to either ...

Custom length Flow Meter cable for use with all Pro series data loggers. Please specify length when ordering.

This 2 pin cable delivers signal and ground connections to both digital and analog sensors. Please specify length when ordering.

Cable to extend V-Net connections.

T-Cable to connect devices like IQ3 Displays, EGTs and data loggers to the V-Net system.

Male terminator cap for V-Net systems.

Female terminator cap for V-Net systems.

This V-Net bulkhead connector allows you to connect your V-Net cables and modules cleanly through a firewall or other chassis tinwork without leavi...

Cable to extend analog (Interface) connections, such as shock travel modules.

This programming cable features a 9 pin serial connector on one end, and a 3.5MM plug on the other, allowing users to program, download and perform...

USB Adapter, Serial to USB Port. This adapter allows you to connect a serial programming cable to a modern PC or laptop. It features a 9 pin serial...

5 pin Autosport cables used to connect transducer boxes and EGT modules on Pro 3 and Pro 3A data loggers. Please specify length when ordering.

13 pin Autosport cables used to connect Input and Analog modules on Pro 3 and Pro 3A data loggers. Please specify length when ordering.

These 5 pin Autosport terminator caps are used to terminate the bus of transducer boxes and EGT modules on Pro 3 and Pro 3A data loggers.

This EGT cable allows you to connect the traditional Pro 3/Pro 3A EGT Junction Boxes to the EGT module on all Pro III series data loggers. Please s...

This EGT cable allows you to connect the Pro 3/Pro 3A JB3 Autosport EGT Junction Boxes to the EGT module on all Pro III series data loggers. Please...

This pigtail connects both magneto outputs to a single 3 pin cable to monitor Mag Phasing on a Pro 3 data logger.

This pigtail features two Deutsch connectors to connect to both magnetos in order to monitor Mag Phasing on a Pro 3 data logger.

Adapts two inductive RPM pickups to a single Molex 3 pin output.

This 3 pin Molex cable transmits data from our TDC (zero crossing) sensors. Used for TDC, Clutch RPM and other rugged RPM inputs. Please specify le...

This cable connects to the MSD 8771 (Top Fuel Power Grid) or MSD 8772 (A/Fuel Power Grid) Ignition Controller, providing up to six additional timin...

This pigtail connects the MSD Top Fuel Power Grid (8771) to your Pro II, providing Delay Box RPM from both Tach outputs on the Power Grid to the Pr...

This pigtail connects the MSD Top Fuel Power Grid (8771) to your Pro III, providing Delay Box RPM from both Tach outputs on the Power Grid to the P...