Sensor

Custom length Flow Meter cable for use with all Pro series data loggers. Please specify length when ordering.

Replacement harness for the 4-channel Air/Fuel modules (220-VM-AF4-XXXX).

This 2 pin cable delivers signal and ground connections to both digital and analog sensors. Please specify length when ordering.

This cable connects to the Power/RPM Hub on the V300SD/V500SD harness to provide an additional RPM input for Clutch or Converter RPM to the V300, V...

This EGT cable allows you to connect your EGT junction boxes into the ‘TEMP’ connection on your Pro 1 or Pro II data logger. This cable is availabl...

This 3 pin cable delivers power, signal and ground connection to both digital and analog sensors. Each cable features a 4 pin connection to either ...

This adapter cable allows you to use components that have a V-Net connection with an X1 data logger.

144" cable with 3-pin Molex connector installed. Allows easy connection of both 5-volt and 12-volt sensors to a Universal Sensor Module by cutting ...

This 3 pin Molex cable transmits data from our TDC (zero crossing) sensors. Used for TDC, Clutch RPM and other rugged RPM inputs. Please specify le...

This thermocouple cable delivers accurate temper readings from a variety of K-type thermocouples. Each cable features a 4 pin connection to a trans...

This pigtail features two Deutsch connectors to connect to both magnetos in order to monitor Mag Phasing on a Pro 3 data logger.

Mag phase cable with 2 pin AMP connector. Please specify length when ordering.

Adapts two inductive RPM pickups to a single Molex 3 pin output.

This EGT cable allows you to connect the traditional Pro 3/Pro 3A EGT Junction Boxes to the EGT module on all Pro III series data loggers. Please s...

This EGT cable allows you to connect the Pro 3/Pro 3A JB3 Autosport EGT Junction Boxes to the EGT module on all Pro III series data loggers. Please...

This cable is used to trigger a shift or warning light from your Pro 3 or Pro 3A data logger. This cable features a 4 pin connection to either a sh...

Replacement driveshaft and 12 volt event wiring harness for the Sportsman data logger.

T-Cable to connect devices EGTs to the X-Bus network.

IQ3 STREET DASH HARNESS

Replacement power, tach and record button wiring harness for the Sportsman data logger.

144" cable with temperature connector installed. Allows easy connection of fluid temp sensors (SN-TR300) to a Universal Sensor Module by cutting to...

This Mag Adapter is required when an inductive Spark Pickup sensor is used to obtain an Engine RPM signal from a MSD 12 amp or 20 amp magneto. Not ...

The V300SD/V500SD RPM Harness is the essential wiring solution for connecting your RPM and power inputs to your V300, V300SD, V500, or V500SD data ...

This adapter harness is used to connect the CAN bus data stream from your ECU to the Universal CAN module, IQ3D (Drag Dash) or IQ3S (Street Dash). ...