RPM Modules

The Series II transducer modules provide a variety of inputs from pressure and temperature, to voltage and strain gauge readings.

This module allows you to connect an additional Engine RPM input to your V-series data logger or dash.

The Pro Input A (RPM) module provides the necessary inputs to monitor Driveshaft, Clutch and Front Wheel RPM on your Pro 1, 1A, 1B or Pro II data l...

This XBus Hall Effect RPM module is specifically programmed for Front Wheel RPM. Designed to pick up off the steel wheel studs with our ferrous-sen...

This XBus module allows users to connect a Hall Effect RPM sensor to the XBus system. Comes with a 120" lead and features a female Molex connector ...

V-Net module to connect an open collector hall effect rpm sensor with a RacePak V-Net system.

The Pro II Input B module provides the necessary inputs to monitor timing on your Pro 1B or Pro II data logger. It connects to your ignition system...

The Pro III Input A Module is a critical component of the Pro-series data logger system, designed to simplify and clean up the wiring between your ...

The PDS series of transducer modules provide a variety of inputs from pressure and temperature, to voltage and strain gauge readings. For use with ...

In order to reduce the number of wires that would be required to connect all of the digital / RPM sensors directly to the X2 recorder (drive shaft,...

In order to reduce the number of wires that would be required to connect all of the digital / RPM sensors directly to the X2 recorder (drive shaft,...

In order to reduce the number of wires that would be required to connect all of the digital / RPM sensors directly to the recorder (clutch, drive s...

In order to reduce the number of wires that would be required to connect all of the digital / RPM sensors directly to the recorder (clutch, drive s...