Sensors

3 pin sensor triggered by magnets to detect Drive Shaft RPM or and other RPM. Features rugged stainless steel housing with 5/16 x 24 thread and 12"...

These pressure sensors work with V-Net pressure modules, USM modules and Racepak Pro modules. Available in 15, 75, 150, 300, 500 psi as well as vac...

Get faster, more accurate driveshaft RPM pickup with the 8 Magnet Split Collar. Designed specifically for automatic-equipped vehicles, the 8-magnet...

Replacement connector used to repair a damaged cable or sensor that connects using a Molex 3 pin connection. Includes both male and female connecto...

These aluminum split collars provide a mounting platform for the magnets that are used to trigger the sensor when monitoring the revolutions of a s...

Exhaust Gas Temperature is one of the most critical data channels for tuning a racing engine, and these 1/4" Gas/Alcohol EGT Thermocouples are purp...

This sensor is commonly used in conjunction with the modules shown below to measure the temperature of fluids such as water or engine and transmiss...

This speed sensor is used to pick up Clutch (input shaft) RPM. It is also used for monitoring Wheel Speed RPM on motorcycles. Features rugged stain...

This oxygen sensor is used with Single and Four-Channel Air Fuel Modules.

3 pin sensor triggered by steel (ferrous) to detect either Ring Gear (Driveshaft RPM) or Front Wheel Speed. Features rugged stainless steel housing...

2 pin driveshaft sensor triggered by a magnetic collar on either the driveshaft or rear end coupler to determine drive shaft RPM. Features plastic ...

2-piece brass ferrule for 1/4" EGT probes.

Exhaust Gas Temperature is one of the most critical data channels for tuning a racing engine — and the 4 Channel V-Net EGT Sensor Set gives you com...

Stainless steel nut and 2-piece brass ferrule for 1/4" EGT probes. Please note that these are sold individually. If you purchase a full set of EGTs...

Mount bracket for drive shaft speed sensor. Features slotted 5/16" hole to accurately align sensor with magnets in drive shaft collar.

Replacement connector used to repair a damaged cable that connects to a 0-300°F temperature sensor (PN: SN-TR300).

This TDC sensor picks up the magnets in the degree wheel to determine the actual ignition timing of the engine. Features rugged stainless steel hou...

Replacement connector used to repair a damaged cable or sensor that connects using a Molex 2 pin connection. Includes both male and female connecto...

The original series transducer modules provide a variety of inputs from pressure and temperature, to voltage and strain gauge readings.

Weldment nut for 1/4" EGT probes.

This connector kit can be used to repair the harness on the Racepak single channel (220-VM-AF1) or four channel Air/Fuel modules.

Replacement connector used to repair a damaged cable that connects to a TI-style pressure sensor.

Get accurate, real-time fuel and hydraulic clutch flow data with the Stainless Steel Flow Meter. These general-purpose turbine-type flow meters are...

This thermocouple-type sensor monitors the temperature of the metal, not the coolant. The ring-style probe has a 12" long cable that is terminated ...