V-NET TRANSMISSION HIGH TEMP MODULE & SENSOR
0-600°F V-Net Transmission temperature and sensor. Comes with a 36" lead.
PDS & Racepak Sensors for Data Acquisition
Accurate data starts with accurate measurement. PDS offers sensors for monitoring the critical variables behind race car performance, including pressure, temperature, RPM, position, fuel flow, and vehicle dynamics. We also support Racepak sensors and legacy applications, helping racers maintain and expand existing data acquisition systems.
Save 0%
0-600°F V-Net Transmission temperature and sensor. Comes with a 36" lead.
Save 0%
The PDS series of transducer modules provide a variety of inputs from pressure and temperature, to voltage and strain gauge readings. For use with ...
View full details
Save 0%
This single-wire sensor is commonly used to pick oil pressure for the IQ3 and UDX Street Dashes, as well as the LDX and UDX Replay Dashes.
Save 0%
Weld-on O2 bung made from mild steel. 18mm thread fits Racepak and Daytona sensors.
Save 0%
These EGT sets provide critical exhaust gas temperature data from 4- and 8-cylinder engines to to the X1 data logger. Sets come with EGT junction b...
View full details
Save 0%
This enclosed tip Type-K thermocouple reacts quickly to changing fluid temperatures in either transmissions or engines. Must be used with the appro...
View full details
Save 0%
These general purpose turbine-type flow meters provide accurate flow readings for both fuel and hydraulic clutch systems. Use of a flow meter and t...
View full details
Save 0%
The V-Net 2-Axis G-Meter provides lateral and longitudinal acceleration measurements for a supported Racepak V-Net system.Confirm compatibility wit...
View full details
Save 0%
This speed sensor is used to pick up Top Dead Center (TDC) on the front hub of the engine. Designed for use with data loggers which have the Timing...
View full details
Save 0%
This probe work with the Skid Pad Amplifier to monitor contact between the vehicle and the racing surface in the event that the skip pad comes in c...
View full details
Save 0%
This module amplifies the signal provided by the skip pad probe to monitor contact between the vehicle and the racing surface in the event that the...
View full details
Save 0%
Complete kit to monitor a single channel Air/Fuel ratio. Includes V-Net module and Single Channel Air/Fuel Controller & Sensor (WEGO IIIS, O2 s...
View full details
Save 0%
WEGO IIIS Single Channel Air/Fuel Kit (includes WEGO IIIS, O2 sensor and weld bung)
Save 0%
Get precise, non-contact chassis ride height data with the Laser Ride Height Sensor. Designed for applications where physical contact with the grou...
View full details
Save 0%
This sensor sources the ignition pulses between the magneto and the control box, and then transfers the signals to the data logger using optic cabl...
View full details
Save 0%
This pickup connects to the "Tach Output" on your MSD ignition and features a 2-pin Molex connector to connect to the RPM harness of a V300 (non-SD...
View full details
Save 0%
This pigtail connects to the MSD Ignition Coil, providing the actual amperage output of your ignition system to your Pro III data logger via a 2 pi...
View full details
Save 0%
Save 0%
Save 0%
This Infra-Red temperature sensor will measure temperatures at a distance of up to 3 feet (1 meter). Common uses are: Tire temperature Track tempe...
View full details