Cables

This Mag Adapter is required when an inductive Spark Pickup sensor is used to obtain an Engine RPM signal from a MSD 12 amp or 20 amp magneto. Not ...

This 3 pin 'Y' cable allows you to provide dual outputs from a single sensor, such as clutch pressure or front wheel speed.

2 pin Molex extension cable. Comes with terminated male and female ends. Please specify length when ordering.

3 pin Molex extension cable. Comes with terminated male and female ends. Please specify length when ordering.

This connector kit can be used to repair the harness on the Racepak single channel (220-VM-AF1) or four channel Air/Fuel modules.

144" cable with pressure connector installed. Allows easy connection of remote pressure sensors to a Universal Sensor Module by cutting to desired ...

144" cable with temperature connector installed. Allows easy connection of fluid temp sensors (SN-TR300) to a Universal Sensor Module by cutting to...

144" cable with 3-pin Molex connector installed. Allows easy connection of both 5-volt and 12-volt sensors to a Universal Sensor Module by cutting ...

Replacement connector used to repair a damaged cable or sensor that connects using a Molex 2 pin connection. Includes both male and female connecto...

Replacement connector used to repair a damaged cable that connects to a TI-style pressure sensor.

Replacement connector used to repair a damaged cable that connects to a 0-300°F temperature sensor (PN: SN-TR300). CN-TR2PInstructions

Replacement connector used to repair a damaged cable or sensor that connects using a Molex 3 pin connection. Includes both male and female connecto...

2-pin mil-spec flow meter connector kit. Includes connector, locking mechanism and heatshrink. Flow Meter ConnectorInstructions

Male Type-K EGT connector.

Female Type-K EGT connector.

Replacement harness for the 4-channel Air/Fuel modules (220-VM-AF4-XXXX).

25ft. 9 pin serial cable extension

This 30′ cable features a 9 pin serial connector on either end, allowing users to program, download and perform telemetry sessions with a V500 data...

XBus cable to connect the ADU7 Display to an X1 data logger.

Replacement power, tach and record button wiring harness for the Sportsman data logger.

T-Cable to connect devices EGTs to the X-Bus network.

This male dust cap is used to prevent debris from collecting in an exposed interface or analog connection.

Male terminator cap for XBus systems.

This adapter cable allows you to use components that have a V-Net connection with an X1 data logger.