Cables

The USB Micro Programming Cable is the essential link between your laptop and your racing electronics. With a standard USB-A connector on one end a...

Programming cable features USB on one end and mini-USB on the other. This 6' cable allows you to program and perform real-time telemetry to certain...

This 32' powered USB extension allows you to program and perform telemetry on your USB connected data loggers.

This cable features a 9 pin serial connection on one end and a 25 pin connection on the other end to either program or view data from a V300 data l...

This 50' cable features a 9 pin serial connection on either end and is designed to send a configuration to a Pro II data logger.

Brass optic nut used to secure optic cable to SC1000, Pro 1, Pro 1B or Pro II data loggers.

Plastic optic nut used to secure optic cable to inductive or battery ignition RPM pickup.

Optically transmits Engine RPM from inductive pickup to SC1000, Pro 1, Pro 1B and Pro II data loggers. Sold by the foot. Be sure to select correct ...

This switch connects to the Input A module on either the Pro 1 or Pro II via a 2 pin cable to turn the data logger on or off. Comes with a 6" exten...

This switch connects to either the Pro IIIA Input A module or the Pro III Input B module via a 2 pin cable to turn the Pro III data logger on or of...

Rugged vibration-resistant power switch.

This adapter connects a remote sensor to a standard 3 pin input cable.

This thermocouple cable delivers accurate temper readings from a variety of K-type thermocouples. Each cable features a 4 pin connection to a trans...

This thermistor temp cable delivers accurate temper readings from a variety of low temperature sensors (PN: 810-TR-300). Please specify length when...

Mag phase cable with 2 pin AMP connector. Please specify length when ordering.

Mag phase cable with 3 pin Deutsch connector. Please specify length when ordering.

13 pin extension cables for Pro 1 and Pro II Input modules and transducer boxes.

This EGT cable allows you to connect your EGT junction boxes into the ‘TEMP’ connection on your Pro 1 or Pro II data logger. This cable is availabl...

This cable is used to trigger a shift or warning light from your Pro 3 or Pro 3A data logger. This cable features a 4 pin connection to either a sh...

Cable to connect Pro Dash to Pro 1B, Pro II or Pro III series data logger.

The V300SD/V500SD RPM Harness is the essential wiring solution for connecting your RPM and power inputs to your V300, V300SD, V500, or V500SD data ...

This cable connects to the Power/RPM Hub on the V300SD/V500SD harness to provide an additional RPM input for Clutch or Converter RPM to the V300, V...

This cable connects to the MSD 7730 Power Grid Ignition Controller, providing up to thriteen additional timing channels from the Power Grid, includ...

This adapter harness is used to connect the CAN bus data stream from your ECU to the Universal CAN module, IQ3D (Drag Dash) or IQ3S (Street Dash). ...