Products

This sensor is commonly used in conjunction with the modules shown below to measure the temperature of fluids such as water or engine and transmiss...

Set of 8 EGT probes for Alcohol and Gas applications. Set consists of 2 ea.: 9", 13", 18" and 23" Probes are secured in the exhaust tubes with the ...

2-piece brass ferrule for 1/4" EGT probes.

Cap for 1/4" EGT bungs.

Weldment nut for 1/4" EGT probes.

Exhaust Gas Temperature is a critical indicator of the performance of a typical racing engine. Supercharged and turbocharged engines use EGT sensor...

Mild steel weldment for 1/4" EGT probes.

Exhaust Gas Temperature is one of the most critical data channels for tuning a racing engine, and these 1/4" Gas/Alcohol EGT Thermocouples are purp...

Exhaust Gas Temperature is a critical indicator of the performance of a typical racing engine. Supercharged and turbocharged engines use EGT sensor...

13 pin Autosport cables used to connect Input and Analog modules on Pro 3 and Pro 3A data loggers. Please specify length when ordering.

13 pin extension cables for Pro 1 and Pro II Input modules and transducer boxes.

These aluminum split collars provide a mounting platform for the magnets that are used to trigger the sensor when monitoring the revolutions of a s...

This 2 pin cable delivers signal and ground connections to both digital and analog sensors. Please specify length when ordering.

2 pin driveshaft sensor triggered by a magnetic collar on either the driveshaft or rear end coupler to determine drive shaft RPM. Features plastic ...

2 pin Molex extension cable. Comes with terminated male and female ends. Please specify length when ordering.

The IQ3 Logger Dash combines a 32 channel data logger with a complete display dash. This eliminates the need for an external data recorder and simp...

3 pin sensor triggered by magnets to detect Drive Shaft RPM or and other RPM. Features rugged stainless steel housing with 5/16 x 24 thread and 12"...

3 pin Molex extension cable. Comes with terminated male and female ends. Please specify length when ordering.

This 3 pin cable delivers power, signal and ground connection to both digital and analog sensors. Each cable features a 4 pin connection to either ...

This 3 pin 'Y' cable allows you to provide dual outputs from a single sensor, such as clutch pressure or front wheel speed.

3 pin sensor triggered by steel (ferrous) to detect either Ring Gear (Driveshaft RPM) or Front Wheel Speed. Features rugged stainless steel housing...

These pressure sensors work with XBus and V-Net pressure modules, USM modules and Pro modules. Available in 75, 100, 150, 200, 250, 300 and 500 psi.

This EGT cable allows you to connect the Pro 3/Pro 3A JB3 Autosport EGT Junction Boxes to the EGT module on all Pro III series data loggers. Please...

This EGT cable allows you to connect the traditional Pro 3/Pro 3A EGT Junction Boxes to the EGT module on all Pro III series data loggers. Please s...