Products

Replacement connector used to repair a damaged cable that connects to a TI-style pressure sensor.

This crank trigger picks up the magnets in the degree wheel and can also be used as a TDC sensor to determine the actual ignition timing of the eng...

The X1 Data Logger Mount makes mounting the X1 recorder very easy. It features a swiveling roll bar mount which is designed to clamp firmly around ...

USB stick featuring software and helpful instructions and tips.

25ft. 9 pin serial cable extension

Stop showing up to the track without the right tools. This Dell Laptop comes pre-configured by Performance Data Systems with everything you need to...

Mag phase cable with 3 pin Deutsch connector. Please specify length when ordering.

This pigtail features two Deutsch connectors to connect to both magnetos in order to monitor Mag Phasing on a Pro 3 data logger.

Mount bracket for drive shaft speed sensor. Features slotted 5/16" hole to accurately align sensor with magnets in drive shaft collar.

This adapter harness is used to connect the CAN bus data stream from your ECU to the Universal CAN module, IQ3D (Drag Dash) or IQ3S (Street Dash). ...

Custom length Flow Meter cable for use with all Pro series data loggers. Please specify length when ordering.

2-pin mil-spec flow meter connector kit. Includes connector, locking mechanism and heatshrink. Flow Meter ConnectorInstructions

This enclosed tip Type-K thermocouple reacts quickly to changing fluid temperatures in either transmissions or engines. Must be used with the appro...

This Flow meter pickup is used with all PDS and Racepak Flow Meters. Can also be added to any Wesco Clutch Flow Meter or other existing Flow Meter ...

The G2X-Pro monitors up to 71 channels and provides lap and segment times along with GPS speed and track mapping.

This thermocouple-type sensor monitors the temperature of the metal, not the coolant. The ring-style probe has a 12" long cable that is terminated ...

This thermocouple cable delivers accurate temper readings from a variety of K-type thermocouples. Each cable features a 4 pin connection to a trans...

Cable to extend analog (Interface) connections, such as shock travel modules.

Adapts two inductive RPM pickups to a single Molex 3 pin output.

This sensor picks up Engine RPM from the ignition coil on a magneto ignition and transmits it via 2- or 3-pin Molex cable connection

This Mag Adapter is required when an inductive Spark Pickup sensor is used to obtain an Engine RPM signal from a MSD 12 amp or 20 amp magneto. Not ...

This Infra-Red temperature sensor will measure temperatures at a distance of up to 3 feet (1 meter). Common uses are: Tire temperature Track tempe...

This male dust cap is used to prevent debris from collecting in an exposed interface or analog connection.

Optimized for the racer who needs to view vital functions quickly and easily, the IQ3 Display Dash can display up to 28 inputs on four pages. All d...