Products

Built for the 4WD pulling competitor who demands professional-grade data acquisition, the 4WD Puller IQ3 Logger Dash Kit combines a 32-channel data...

5 pin Autosport cables used to connect transducer boxes and EGT modules on Pro 3 and Pro 3A data loggers. Please specify length when ordering.

This EGT cable allows you to connect your EGT junction boxes into the ‘TEMP’ connection on your Pro 1 or Pro II data logger. This cable is availabl...

Get faster, more accurate driveshaft RPM pickup with the 8 Magnet Split Collar. Designed specifically for automatic-equipped vehicles, the 8-magnet...

This programming cable features a 9 pin serial connector on one end, and a 3.5MM plug on the other, allowing users to program, download and perform...

This crank trigger picks up the magnets in the degree wheel and can also be used as a TDC sensor to determine the actual ignition timing of the eng...

The ADU7 display is the perfect complement to our X1 data logger. The 7″ Advanced Display Unit features a  high resolution, high visibility anti-gl...

Carbon mount bracket for the ADU7 Display Dash.

This connector kit can be used to repair the harness on the Racepak single channel (220-VM-AF1) or four channel Air/Fuel modules.

This oxygen sensor is used with Single and Four-Channel Air Fuel Modules.

Replacement harness for the 4-channel Air/Fuel modules (220-VM-AF4-XXXX).

The AirHub allows you to turn your race vehicle into a wireless network. Connect up to 4 USB devices simultaneously and access them remotely via yo...

These general purpose turbine-type flow meters provide accurate flow readings for both fuel and hydraulic clutch systems. Use of a flow meter and t...

This pigtail connects both magneto outputs to a single 3 pin cable to monitor Mag Phasing on a Pro 3 data logger.

These 5 pin Autosport terminator caps are used to terminate the bus of transducer boxes and EGT modules on Pro 3 and Pro 3A data loggers.

Charging pigtail for Pro 3 and Pro 3A battery charger

Battery charger for Pro 3 and Pro 3A data loggers. Features status LED to indicate when the internal battery is fully charged.

Battery charger for Pro 1 and Pro II data loggers. Features status LED to indicate when the internal battery is fully charged.

Mount bracket for Clutch linears. Allows for secure mounting of the linear to a Moore/Nitro Performance reverser.

Spring-loaded linear travel sensors are designed to monitor the release (throwout) bearing on clutches. Features: Clutch Linear Sensors - 3” and 4...

This speed sensor is used to pick up Clutch (input shaft) RPM. It is also used for monitoring Wheel Speed RPM on motorcycles. Features rugged stain...

Replacement connector used to repair a damaged cable that connects to a 0-300°F temperature sensor (PN: SN-TR300). CN-TR2PInstructions

Replacement connector used to repair a damaged cable or sensor that connects using a Molex 2 pin connection. Includes both male and female connecto...

Replacement connector used to repair a damaged cable or sensor that connects using a Molex 3 pin connection. Includes both male and female connecto...