Products

Interface module used to connect shock travel sensors to the high speed analog port. Please select shock position and length from list when ordering.

Single channel Air/Fuel module, harness and sensor.

WEGO IIIS Single Channel Air/Fuel Kit (includes WEGO IIIS, O2 sensor and weld bung)

Complete kit to monitor a single channel Air/Fuel ratio. Includes V-Net module and Single Channel Air/Fuel Controller & Sensor (WEGO IIIS, O2 s...

V-Net module to connect Single Channel Air/Fuel Controller & Sensor to V-Net enabled data loggers and displays.

This single-wire sensor is commonly used to pick oil pressure for the IQ3 and UDX Street Dashes, as well as the LDX and UDX Replay Dashes.

This single-wire sensor is commonly used to pick up coolant or transmission temp for the IQ3 and UDX Street Dashes, as well as the LDX and UDX Repl...

This module amplifies the signal provided by the skip pad probe to monitor contact between the vehicle and the racing surface in the event that the...

This probe work with the Skid Pad Amplifier to monitor contact between the vehicle and the racing surface in the event that the skip pad comes in c...

Spindle mounted bracket for front wheel speed sensor. Features spindle bolt pattern and threaded 3/8" hole to securely fasten sensor in place.

The Sportsman Data Logger brings professional-grade V-Net data acquisition technology to the sportsman drag racer at a price that makes sense. The ...

Replacement driveshaft and 12 volt event wiring harness for the Sportsman data logger.

Replacement power, tach and record button wiring harness for the Sportsman data logger.

Get accurate, real-time fuel and hydraulic clutch flow data with the Stainless Steel Flow Meter. These general-purpose turbine-type flow meters are...

Mag phase cable with 2 pin AMP connector. Please specify length when ordering.

Weld-on O2 bung made from mild steel. 18mm thread fits Racepak and Daytona sensors.

The IQ3 Logger Dash combines a 32 channel data logger with a complete display dash. This eliminates the need for an external data recorder and simp...

Two piece adapter fitting to adapt 3/16” thermocouple probe to 1/8 NPT.

This 3 pin Molex cable transmits data from our TDC (zero crossing) sensors. Used for TDC, Clutch RPM and other rugged RPM inputs. Please specify le...

144" cable with temperature connector installed. Allows easy connection of fluid temp sensors (SN-TR300) to a Universal Sensor Module by cutting to...

This cable connects to the MSD 8771 (Top Fuel Power Grid) or MSD 8772 (A/Fuel Power Grid) Ignition Controller, providing up to six additional timin...

Female Type-K EGT connector.

Male Type-K EGT connector.

0-1.0” linear travel sensor, used to monitor throttle position. Also can be used to monitor fuel system slide valve movement.